It is currently Tue Sep 01, 2026 4:15 pm


BSOD - page fault in non paged area

All versions of Windows 7, 2008 and Vista including 32 bit and 64 bit

Moderator: icecube

BSOD - page fault in non paged area

Postby Storm_Raider » Sat Jan 20, 2007 5:20 pm

Hi ive recently been getting BSOD's with the message "page fault in non paged area" does anybody know what this is or what causes it. Ive tried other forums but to no avail.
User avatar
Storm_Raider
Newbie
Newbie
 
Posts: 11
Joined: Wed Mar 01, 2006 1:00 am

Thanks given:0
Thanks received:0
Top

Postby Gecko » Sat Jan 20, 2007 9:53 pm

User avatar
Gecko
Super Moderator
Super Moderator
 
Posts: 5209
Joined: Thu Oct 25, 2001 1:00 am
Location: Florida, USA

Thanks given:1
Thanks received:23
Top

Postby Storm_Raider » Sun Jan 21, 2007 7:04 pm

User avatar
Storm_Raider
Newbie
Newbie
 
Posts: 11
Joined: Wed Mar 01, 2006 1:00 am

Thanks given:0
Thanks received:0
Top

Postby Gecko » Sun Jan 21, 2007 8:29 pm

Storm_Raider,

The fact that you are getting both errors only adds a hardware failure possablity to the mix.
Most likely it a driver issue but I wouldn't rule out ram until it was tested, even if it's new.

I would first make sure windows is fully updated and then check for new drivers for all of your devices.
I would look at you network card driver first I saw a number of references to bad nic drivers at MS.
You should also check to see if there is a BIOS update for your motherboard.

Microsoft has an article on using their Driver Verifier tool if you want to try that route
User avatar
Gecko
Super Moderator
Super Moderator
 
Posts: 5209
Joined: Thu Oct 25, 2001 1:00 am
Location: Florida, USA

Thanks given:1
Thanks received:23
Top

Postby BrentBertsch » Mon Jan 22, 2007 6:05 pm

BrentBertsch
Newbie
Newbie
 
Posts: 13
Joined: Thu Jan 18, 2007 9:54 pm
Location: Colorado

Thanks given:0
Thanks received:0
Top

Postby Storm_Raider » Tue Jan 23, 2007 3:38 am

Well it turns out it was my own fault for the BSOD's at the time i started getting them id upgraded RAM graphics card and soundcard. So after retracing my steps and by sheer luck i happened to check the IRQ allocations and well it turned out that my soundcard and graphics card were both sharing IRQ 18. So i moved the soundcard to a different pci slot and tada problem solved.

Thanks for your help anyway.
User avatar
Storm_Raider
Newbie
Newbie
 
Posts: 11
Joined: Wed Mar 01, 2006 1:00 am

Thanks given:0
Thanks received:0
Top


Return to Windows 7, 2008 and Vista

Who is online

Users browsing this forum: No registered users and 1 guest

cron