Bios Problem
Posted: Thu May 12, 2005 6:38 pmPage 1 of 1
Posted: Thu May 12, 2005 6:38 pmPosted: Thu May 12, 2005 7:28 pmerm i would prbly re-install windows see if that works
Posted: Thu May 12, 2005 8:42 pmI would clear the BIOS by using the jumper
Then go into the BIOS and set it to default and see if it will boot into windows.
If it still fails to boot I would format and clean install.
Then go into the BIOS and set it to default and see if it will boot into windows.
If it still fails to boot I would format and clean install.
Posted: Fri May 13, 2005 7:04 pmPosted: Sat May 14, 2005 3:15 pmPosted: Sun May 15, 2005 12:11 amPersonally, if everything was working fine before you updated the bios i would reflash to the version you had before OR i would manually download the correct bios from the website and reflash with it. I have to pull up your original post but i think there was an issue with the new bios being the wrong one for your board. The jumper only clears out settings, it doesnt restore previous versions. I would do that and then format if needed after.
Posted: Sun May 15, 2005 1:13 pmok cool thanks for the replies. i just downloaded the correct version and made a bootable floppy, but i've never updated bios this way before. is it hard? any tips? things to avoid?
Thanks again.
Thanks again.