Hi speed USB host controllers...

[Junior_co]

I get this message when I plug in my nifty new jump drive...

The USB Mass Storage Device will function at reduced speed. You must add a HI-SPEED USB host controller to this computer to obtain maximum performance.

Does this mean a hard ware change or is there a software setting somewhere that would change this???

I'm thinking that the USB's are all coming off the mother board, but won't know for sure till a this weekend. (work and stuff gettin in the way....)

Also, if you wouldn't mind... A little bit of back round info on this topic would be great....

Thanks again

Junior

[Limp]

Your motherboard may have USB 1.0 or 1.1 and your jump drive may be designed to use USB 2.0 interface for full performance. You could get a card that supports usb 2.0. Here is a link to one of those cards » .
Here are a few articles that you could check out also»



Hope this helps